■商品概要
【メーカー品番】280-903H■詳細説明
HIGHSIDER AKRON-RS license plate holder
The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your bike thanks to its design．
The model-specific bracket of the AKRON-RS allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting．
To prevent damage to cables， all sharp-edged feedthroughs are protected by a rubber membrane grommet．
The license plate is made of sheet steel and 2 mm thick． The precise cutting is done by laser． After edging， the weather-resistant black powder coating is applied．
This ensures the optimal fit and durability．
Through the stepless adjustment you can bring the plate without drilling in the desired position． To keep the plate in this position， there is an additional locking screw．
The AKRON-RS turn signal brackets are adjustable in width and therefore suitable for any type of accessory turn signal． This adjustment option allows you to adapt the position for your turn signals to the most varied number plates． To allow mounting the turn signals without disconnecting them from the wiring harness， the 10 mm holes are slotted to the side．
You can also adjust the position of the reflector individually via a slider． An adaptation to the different designs of the EU license plates is therefore no problem．
To screw the license plate securely and reduce vibration， two rubber washers are included． Another rubber buffer supports the license plate on its underside．
Details:
- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector， E-approved
- suitable for European number plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixing without further work steps (e． g．B． Drilling)
- easy mounting of the license plate through slotted holes
Included with the AKRON-RS are:
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable turn signal brackets
- E-tested reflector with adjustable bracket
- Mounting instructions
Notes:
- If there are side reflectors fitted to your original number plate holder， these must be refitted in a suitable position or replaced with new ones．
- The special turn signal holder 280-977 is optionally available for the original turn signals．
Tip:
If you have not found a model-specific license plate holder for your vehicle， the universal license plate holders from HIGHSIDER， which are available in many different designs， are certainly a good alternative．■注意点
※ナンバープレートサイズが日本の規格ではありませんので、取り付ける際にはステーによる加工などが必要なりますのでご注意下さい。
※輸入品のため、説明書が付属する場合、外国語の説明書となります。
※メーカー都合により商品の仕様変更がある場合がございます。ご了承ください。
※画像はイメージです。■適合車種
YZF-R1 (RN09)
YZF-R1 (RN09) 年式: 02-03
YZF-R6 (RJ05)
YZF-R6 (RJ05) 年式: 03
YZF-R6 (RJ09)
YZF-R6 (RJ09) 年式: 04-05 ■商品番号
1108305